TACTICAL-14 Installation Instructions

Figure A

1. Remove Magazine

Remove magazine and ensure safety is engaged. Please note the hammer must be cocked and safety engaged to disassemble firearm. (See Figure A.) Refer to rifle manufacture owner’s manual.

Figure B

2. Trigger Guard

Turn rifle upside down. Using a 1/4” rod (example: screwdriver, punch) in the hole on the rear of the trigger guard lift up on the trigger guard to unlatch guard. (See Figure B.) Refer to rifle manufacture owner’s manual.

Figure C

3. Remove Trigger

Remove trigger with an upward motion. (See Figure C.) Refer to rifle manufacture owner’s manual.

Figure D

4. Remove Hand Guard

Separate receiver/barrel assembly from stock and remove hand guard assembly. (See Figure D.) Refer to rifle manufacture owner’s manual.

Figure E

5. Remove Liner

Remove the forend liner/heat shield from original stock by carefully prying on rear slotted tab and retain for use with SFS Tactical-14 Lower. (See Figure E.) Refer to rifle manufacture owner’s manual.

Figure F

6. Install Liner

Snap the forend liner/heat shield into your new SFS Tactical-14 Lower Housing. (See Figure F.)

Figure G

7. Install Lower Receiver

Lower the receiver/barrel assembly into the SFS Tactical-14 Lower Housing and reinstall trigger assembly locking it in place. (See Figure G.)

Figure H

8. Install Top Rail

Snap the SFS Tactical-14 Top Rail into place by inserting tab into the front metal collar (gas block). Push down to lock into place and fasten with Phillips pan head screw (provided) into rear of chassis. (See Figure H.)

Figure I

9. Install Top Rail

Install A-2 Adjustable Stock by retracting latch and sliding onto backend of lower. Fasten A-2 Pistol Grip with lock washer and socket head screw (provided).